Coleman & Laurienzo Builders
26212 Ridge Rd
Damascus, MD 20872 301-253-9616
Damascus, MD 20872 301-253-9616
Ratings
Consumer Ratings for Coleman & Laurienzo Builders — 3 Ratings
Percent of customers who rated service "superior" for:
Doing service properly on first try
Promptness
Letting you know cost early
Neatness of work
Pleasantness
Advice on service options and costs
Overall quality
Prices
Consumer Comments for Coleman & Laurienzo Builders
Oct 17, 2017
The moisture in there was so great that some of the batt insulation has fallen down. There may be a slight amount of mold on the joist.
I have tried to remedy the problem the best I can by:
• Ensured proper drainage of water away from house by diverting downspout water away with the use of drainage pipes
• I installed a crawlspace vent fan.
• Above ground, water diverting tactics.
Ultimately, a water resistant coating on the outside of the cinder block foundation most likely would have stopped any water intrusion. The best time to have done this would been at the begging stages of foundation work. Now it is more difficult to waterproof. I recognize this is not required by construction code, but it would have been a good practice.
Issue 2 – Inadequate insulation around exterior of bookcase, where the old fireplace was located.
Issue 3 – Connection and Routing of Dryer Duct
During the construction phase, your workers did not connect the duct work to properly vent the dryer. The dryer was used many times before I caught that issue, near the end of construction. Because the area to work in was tight, I distinctly remember the worker squabbling over who was going to do the work(make the connection). The vent duct was already lengthy and not the best quality; the addition made the existing vent duct run even longer. Between the existing subpar duct and additional length, the venting continuously clogged. Me and my wife analyzed the situation and came up with a much shorter routing. We make the fix ourselves. Here, better judgment from your team should have recognize the existing duct was going to be an issue. Would have been worth extra cost.
Jun 19, 2017
Dec 01, 2013